This project was submitted by one of our readers, just like you.
Trikeroid Netroid Toy
From the designer: "Trikeroid Netroid is a burly robotic Triceratops and comes with its own Poid rider! Chrome and metallic patterns make this model shine (figuratively)! This two page model includes a dinosaur robot and a character that can ride it! The dino body is made of three main parts and has two points of articulation. The neck can bend down and the body can twist at the hips for great poses! The model uses PopLocks by Josh Buczynksi under a Creative Commons license."
Time to CompleteUnder an hour
Primary TechniqueGeneral Paper Crafting
Project or Page Size8.5 inches x 11 inches
Type of Paper UsedCardstock
Instructions
-
Locate scissors and a 5/8" hole punch (available at most craft stores). If a hole punch is not available you can use an exacto knife with the inner hole of a CD as a template.
-
Print both pages onto 65# to 80# card stock.
-
Cut three body parts out. Punch or cut 5/8" holes.
-
Cut PopLocks out. Crease each PopLock in half along the short width.
-
Use the on-page part letters to put the model together.
-
Refer to netroids.net for PopLock tips.
Read NextAwesome Printable Tyrannosaurus Rex
Your Recently Viewed Projects
jamesf
Jul 05, 2022
The PDF can now be found at https//sites.google.com/site/netroiduniverse/ho == me/wave-3
Report Inappropriate Comment
Are you sure you would like to report this comment? It will be flagged for our moderators to take action.
Thank you for taking the time to improve the content on our site.